If the instrument is directly connected to the machine battery (optional, refer the LOADTRONIC 3 Installation Guide), the activation time is less than 1 seconds if the engine is stalled normally activation time is approximately 10 seconds. The currently active job record is shown in the lower part of the display if all records have been cleared (no active record) job record 0 ‘ Unspecified Recording’ is displayed. LOADTRONIC 3 is now ready for automatic weighing, refer chapter 3.2. After a few seconds a start up window is shown in the display next the system enters automatic weighing mode. LOADTRONIC 3 starts up as the machine’s ignition key is set in position 1 (running position) and the power switch at the rear of the main unit is switched ON/1. The main unit is mounted on the right corner post in the cabin, and has the following functions: The main unit is a combined operator’s display and a computer unit. In addition, the system is connected to the reverse signal of the machine. One bucket position switch to signal when the bucket is fully retracted. One acceleration sensor which measures the movement (acceleration, retardation and the inclination of the machine). One angular sensor (inclinometer) which measures the position of the lifting arms. There are two more sensors in the system: These sensors measure the forces applied to the lifting arm system, refer LOADTRONIC 3 Installation Guide. LOADTRONIC 3 has two pressure sensors fitted to the hydraulics of the wheel loader. LOADTRONIC 3 is type approved as Automatic Catchweigher according to MID-directive MI-006 and OIML R51. It is automatic in the respect that the load in the bucket is weighed without any involvement from the operator and dynamic as the weighing is done while the machine operates normally without any interruption for weighing. LOADTRONIC 3 is an automatic and dynamic weighing system for wheel loaders. īackup and Restore Logfiles, Database and System Files.Ĭopy Calibration Details. Ĥ.2.1 Report Header.Ĥ.2.2 Total Load Report.Ĥ.2.3 Specified Report. Ĥ.1.3 Enter Job Details from the Job List.Ĥ.1.4 Enter Job Details from the Text Editor. Ĥ.1.1 Search the Library for a Customer, Truck etc.Ĥ.1.2 Special Characters. Library of Customers, Materials, Trucks and Locations. ģ.11 Adjusting the Display Backlight.ģ.12 Display Volume of Load.ģ.13 System Information.ĬHAPTER 4 Library and Reports. Ĭancelling/Dumping last Bucket.ģ.10 Pause mode. Manual Weighing.Ĭhanging and Deleting Attachment. ģ.3.4 Selecting a Pre-defined Job Record. Recording.ģ.3.1 Job Record.ģ.3.2 Unspecified Recording.ģ.3.3 Specified Recording. Start –Normal Operation.Īutomatic Weighing.ģ.2.1 Tips for best results when weighing. Menu Layout.ĬHAPTER 3 Operating LOADTRONIC 3.
Ĭertified Technical Data.ĬHAPTER 2 Operator Display and Menu. Remote Wireless Communication (Optional).
0 kommentar(er)
